![]() There are more projects on the Internet, but most I have seen are crappy implementations of these units (some people think that because these drivers are expensive you do not need a good crossover to get a proper loudspeker :evil: ).Īlso some designs, using the older units, can be found in the German DIY magazines. I did not hear these, but from a technical point of view these seems to be much beter (measurements performed in an anechoic room ) ![]() So, anyone has completed anything using Accutons?Tony's designs are also not my cup of tea, but iirc Marc Heijligers also did a alternative x-over for the same driver configuration, which is in my view a much better implementation. ![]() I see the C79 is mentioned quite a bit on this forum, but all complete projects are based on Dayton etc. I'm not the person to give up my dreams, so I was thinking to try the C79, and only complete project I can find on the web is Milestones. My last attempt was Tony Gee's Soup Ceramique, but I didn't like the sound, and then I dropped one of the mid drivers and BAM!, it cracked. Incidentally, I did build a number of different speakers and didn't like them, so my ultimate speakers are yet to be built. Cart 0 Product Products (empty) No products. Currency : EUR (USD) Euro (EUR) GBP (GBP) English. I been lurking here for years, aiming to build some top quality speakers. Accuton manufacturer of high quality speaker drivers with hard membranes made of diamond, corundum ceramics and aluminum sandwich. Hello to all great participants of this forum!
0 Comments
Leave a Reply. |